oval instrument cluster

[Peter J Larsen]

I like to remove the instrument cluster from the Inno ( 3 instruments
where are the connection?? and how to do it. the reason I like to replace the Oilpressure gauge. The reason moving the whole cluster, it is very very hard to reach
the Oilgauge through the firewall
any Help>?
peter

[Cheleker]

The Innos usually did things a little differently and I don't remember how yours is set up. A photo might help. Or a quick look at the dash at the Monday meeting.

[Jerry]

Peter, any luck with the oil pressure gauge??

[Peter J Larsen]

jerry,
I found the 4 spots where the oval is attached just behind the carb
I have a new Oel temp gauge and will have a new oelpressure cable.
so I m readfy to go.

thks
peter

[Peter J Larsen]

so the new oelpressure line which consist of the
plastic line/ and 2 small metal" sleves" which I believe goes in the line
and of course the 2 connector to the instrument and block
how do you attach the sleeves in the line and keeping it fromfalling out.?

[mascher]

The oil pressure guage lines I have seen use compression fittings. The 'sleeves' are possibly what are called olives in compression fittings and are used basically as seals. It's probably best that you do an internet search on compression fittings and possibly the word olive to see how they work. I doubt that I could explain it very well here.

Kelley

[Peter J Larsen]

thanks,
will bring the parts I have to the Tuesday meet, to discuss

peter