Tweet
Over the past couple weeks I renewed the rear radius arm bushing & needle bearings. I was installing the RH side last night and on the fwd outboard side there is a bracket secured with 4 bolts. As I was tighening down on of the bolts the weldnut popped of inside the subframe and now spins freely. Any suggestions? Do I need to drop the subframe? Think a rivnut is strong enough? Thanks
-
_______________________________________________
Some times it's not worth chewing through the restraints. -
Well after a little deliberation with a couple of folks at work a friend offered to weld in a couple of new nuts._______________________________________________
Some times it's not worth chewing through the restraints.
Comment