Announcement

Collapse
No announcement yet.

1275 A+ Crank Pulley Bolt

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1275 A+ Crank Pulley Bolt

    Trying to disassemble a spare 1275 A+ block.
    Anybody know what size socket will fit the crank pulley bolt?
    My 1-1/4" socket is too small.
    Maybe a 32mm socket is the correct size?...
    Jerry C
    Jerry C
    "You drive...I think there's something wrong with me"

  • #2
    All of the pre A+ stuff I have worked on had a 1-5/16 wrench size.
    Chris Miller

    Comment


    • #3
      I haven't run into a metric crank pulley bolt, yet. Start with 1 5/16" socket. If it doesn't fit, try 34mm, but I'm pretty sure you find 1 5/16" works.
      The more I know about Minis, the more I know I don't know about Minis.

      Comment


      • #4
        Jerry, if you need to borrow a 1 5/16" socket I have one I can loan you. The club has a 34mm socket for the metric hubs as well.

        Kelley
        If you can afford the car, you can afford the manual...

        Comment


        • #5
          Thank you all for the feedback. I don't have any sockets larger than 1-1/4" and didn't want to have to guess.
          Appreciate the offer to borrow yours Kelley but I think I'll go procure my own since I'll hopefully be needing it again at some unspecified point in the future.
          Jerry C
          Jerry C
          "You drive...I think there's something wrong with me"

          Comment

          Working...
          X